Just a quick video outlining the logic of how to convert DC electricity into AC. This process is useful for driving AC motors at different speeds, changing s…
Video Rating: 4 / 5
Dec
31
How to Convert DC to AC
Leave a Reply
Solar Panel & Windpower made easy
Solar DIY Wind Power – Green Power Easy Reviewed
Photovoltaic Solar Panels – homemade DIY energy
8 comments
No ping yet
3deeguy says:
December 31, 2014 at 12:31 pm (UTC 0)
I’ve started to wonder how to create a 60hz sine wave from DC. I plan to
use a Parallax Propeller to control the circuit. I subscribed to follow the
discussion. The math for transistors is easy. I need to learn mosfets
David Schmidt says:
December 31, 2014 at 12:35 pm (UTC 0)
pretty cool, I learned in Electrical school .how to take AC/ and make it
into DC/ by useing a bridge circuit called a rectifier either full or half
wave .I just lately have been screwing around with some mosfets ,and
building a cell phone charger on the go .so now i see another alternative
.thanks .
Mohamed al hasheem says:
December 31, 2014 at 12:53 pm (UTC 0)
code please,
Nick Sek says:
December 31, 2014 at 12:59 pm (UTC 0)
Just a quick video outlining the logic of how to convert DC electricity
into AC. This process is useful for driving AC motors at different speeds,
changing solar panel power into AC electricity. Enjoy the video!
Nick Sek says:
December 31, 2014 at 1:06 pm (UTC 0)
This is going to feed into a control circuit, which I will be using to make
a portable high voltage power supply for a secrete project I am starting!
Thanks for being active in the channel!
Nick Sek says:
December 31, 2014 at 1:33 pm (UTC 0)
First off thanks for the positive feedback! I really like the idea of using
a low-pass filter to smooth out the output of this device, though I think I
should take it to the next level by creating more of digital to analog
convertor and utilizing a resistor ladder, maybe using an inductor in
series to the load and a filter capacitor to ground to really get nice
curvature. I think you inspired me to create a better quality invertor,
thanks for the motivation. Nick
Falk Bay says:
December 31, 2014 at 2:24 pm (UTC 0)
Nice Work, but you should always put first one pin LOW and then the other
one HIGH, just swap two lines in the arduino program. Both pins LOW isn’t a
problem, but both HIGH is a big problem, even if its less than one ms.
Nick Sek says:
December 31, 2014 at 2:45 pm (UTC 0)
Every true, thanks for pointing that out. Though catastrophic failure would
make for a more exciting video!